Flashing pipe penetration

Vent Pipe Flashing - Copper Roof The copper base flashing extends a minimum of 6" onto the roof in all directions. Your response will be greatly appreciated. Penetration-Free Attachment Standing seam metal actually offers advantages over other roof types when mounting of ancillary fixtures does become necessary. This flashing assembly, which is sealed to the roof with butyl copolymer tape sealants, should offer 20 or more years of service life. Pipe Penetration with Wood Curb This detail shows a penetration with a wood curb. But following these guidelines will help to ensure trouble-free and enduring performance for low-slope metal roof systems. Cut the fleece pieces so that they overlap by at least 7.

These incisions should be 5 to 7 cm deep and 1 cm wide. This sleeve runs up to the top of the vent pipe. Popular Products and Pages: Long Pipe Flashing This detail is used for pipes that continue above the roof, and cannot be flashed as shown in Detail 9. Straps may be attached inside the stack section of the ventilator and to the structural framing for additional support. Roof Area Divider 9.

The roof edge of the flashing is locked and soldered into a copper apron. We also have every type of Retrofit Flashing Boot Rubber roof-pipe flashings are designed to seal round penetrations and can be use in all types of roofs or walls. This detail illustrates a method of flashing a ventilator on a sloped roof. Flashing Boot Size inches. Manufacturers We appreciate all feedback and comments about the 4specs "Specified" Products Library Service.