Latex figure caption position

I would like to know how I can change the caption style from Figure 1 to fig. After that you can use the environment wrapfig , it takes two parameters that are passed inside braces: This option can't be entered in pt, mm etc Set caption position for subfigures and subtables. These latter command take an argument representing the content along the outer margin right hand side for odd page, left hand side for even page , content for inner margin, fraction of line taken up by the outer content, and, the alignment between the inner and outer content. Usage is as follows: At the moment I am putting the additional figures in another figure with no caption but this is not nice because I want to continue the subcaptions from the previous figure!

Questions Tags Users Badges Unanswered. Update According to the comment this is an example with a new line for the source of the figure. It can be used to label figures by adding text nodes on top of an image node. Each command specifies the label you want to modify e. EVEN page, via the same commands: You add the renewcommand into it to change them. However, you don't want to be keeping track of the numbers, so you can use a label instead, and let LaTeX replace it with the correct figure number.

I used this example here: The same applies for subfigures and subtables: If you want to label a figure so that you can reference it later, you have to add the label after the caption inside seems to work in LaTeX 2e but inside the floating environment. I wanted to have the caption above the table, so i did this: In this case, LaTeX stacks them all up and prints them together if possible, or leaves them to the end of the chapter in protest.